Specifications
STANDARD SPECS
The specifications below apply to all Powerglide Elevators.
Rated Load: Up to 340kgs
Speed: 300mm/sec up and down. More detail…
Drive System: Hydraulic, powered in both directions. More detail…
Power Supply: Permanent single phase 20 amps with isolating switch
Travel Distance: Up to 9,600mm
Car Floor Size: Maximum of 1400mm x 1400mm (rectangle or square). Refer to individual product pages for model specific sizing.
Configuration: Doors on up to three sides, depending on model. More detail…
Car Height: Up to 2400mm
Well and Pit Size: Refer Lift Shaft Size Guide
Pit Depth: No less than 300mm from bottom landing. More detail…
Cylinder Hole Depth: Refer Lift Shaft Builders Guide
Clearance above Car: Minimum 100mm, with no ceiling space machinery. More detail…
Control System: PLC via 24V maintenance free batteries
Door Latching: Double monitored electric strikes
Lighting: LED
Car Construction: RHS Steel
Welding: All welding is by certified welder
Guides: Self lubricating UMPHWE
Guide Rails: Self supporting, rolled steel channel. More detail…
Lift Walls & Ceiling: Melamine panels in a range of styles and colours
Landings: Up to 5
Referenced Regulations: Complies with NZS4121:2001 up to 3 floors, NZBC D2/AS1 as an acceptable solution using NZS4334:2012, and as an alternative solution using AS1735.18 2002 in conjunction with NZBC D2/AS1.
MODEL SPECIFIC SPECS
For model specific specs, please refer to the relevant product page.